When a print is completed, the printer will enter a low power mode, but it will not completely shut down.ĭark Mode is not supported by Bambu Studio right now. ¶ Does the printer support auto-shutdown? Also, the printed model can cover the calibration lines. The calibration can be disabled when printing. The printed calibration lines take a bit of space on the front of the printing surface, but that is only required when changing the filament or nozzle. ¶ Is the build volume smaller when the calibration is performed? When the build plate is brand new, the bond is too strong and easy to damage the print surface, so applying glue can help better remove the model from the glue layer. The adhesion of PC will decline after a long time of use, and applying solid glue can ensure stable bonding strength. There are two major benefits of using the glue stick: to enhance adhesion and make removing prints easier. ¶ Why is the Glue Stick used on the printing surface? ¶ How to export the log file to an EXISTING support ticket? The process is described in this Wiki article ¶ How to export the log file to a NEW support ticket? If you want to use a 64GB to 2TB micro SD card, you could format it to FAT32 using Linux or Mac system or the printer. For Windows, the default format would be exFAT if the micro SD Card storage is over 32GB, while there is no such limitation for Linux and Mac. After that, the new video will flush out the old video. If the remaining micro SD card memory exceeds 15%, you can record printing videos until 85% of the micro SD card memory is occupied. When the memory of the micro SD card is occupied 85% or more, the video cannot be recorded. Our printer will only use 85% of the micro SD card's memory at most. The X1/X1C supports an micro SD card of up to 2TB if formatted using the printer option. ¶ What is the maximum micro SD card capacity compatible with the printer? The steps for printing from the micro SD card are available on this Wiki The filter is sealed, and it can be replaced with the official Bambu Lab filter available in our shop, or with any 3rd party filter with 82mm*50mm*29mm dimensions. We recommend replacing it every 2-3 months. The change frequency for the filter depends on how often you use the printer, and the type of filament used. ¶ How often does the VOC filter need to be replaced? Here's a link to a complete list of parts that can be consulted in this link The X1/X1C doesn't need a lot of maintenance. ¶ What kind of maintenance is expected for the X1/X1C? During printing, you can turn on/off the fans in Bambu Studio or on the display screen but can not tune the speed. Before printing, you can adjust the fan speed of the Part Cooling Fan and the Auxiliary Part Cooling Fan in the slicer. Only Part Cooling Fan and Auxiliary Part Cooling Fan (if any) can be controlled in the slicer or via the on-screen buttons. ¶ Can the fans be manually turned on/off? The chamber temperature increases based on the temperature set for the heated bed and cannot be precisely controlled. But at the same time, if transitioning from a dark color to a light color, the purge amount can increase. With careful tuning, such as reducing the flush volume or the prime tower size, the waste amount can be lowered. The amount of filament purged during color changes depends on the type of color and how long the color transition takes. ¶ Can we reduce the amount of purge material during color changes? The power socket is at the back of the printer. If you are using AMS, you should keep some space for your hand to reach the purge basket. We recommend 10cm on each side for cooling and ventilation. ¶ What are the clearance requirements around the printer?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |